Conbextra EP10 1.5L Pack

Conbextra EP10 1.5L Pack
  • Conbextra EP10 1.5L Pack

Conbextra EP10

Conbextra EP10 is a low viscosity epoxy grout for grouting small gaps (<10mm) between a base plate and substrate. Conbextra EP10 can be used to fill hairline cracks in concrete slabs.

Select
  • CONBEXTRA EP10 1.5L PACK
  • CONBEXTRA EP10 15L PACK
  • CONBEXTRA EP10 300ML PACK

Typical Applications

  • Grouting small gaps (<10mm) under baseplates
  • Crack repair material

Advantages

  • High compressive, tensile and flexural strengths
  • Resistant to repetitive dynamic loads
  • Fast, convenient installation with early strength gain
  • Withstands a wide range of chemicals
  • Non-shrink and hence ensures complete surface contact and bond
  • Low creep characteristics under sustained loading
  • 28 day strength @ 20°C dependent on consistency (cube samples) : 83 MPa
  • Application method : Gravity feed, pressure injection
  • Chemical resistance : Resistant to oil, grease, fats, most chemicals, mild acids and alkalis, fresh water and sea water
  • Flexural Strength (modulus of rupture) @ 28 days : 30 MPa
  • Gap size : 01 mm to 10 mm
  • Indirect tensile strength @ 28 days : 15 MPa
  • Pot life @ 20°C : 20 mins
  • Service temperature : 10°C to 45°C
  • Tack free time : Free flowing

Enter dimensions of your application to caclculate the volume and the bag/kit quantity you will need.

Note: This calculator should be used as a guide only to determine product quantity requirements. Coverage rates can vary, depending on a number of factors, so for specific advice, please refer to the TDS, and/or call your Account Manager or our Customer Service team to discuss your application requirements.

enter the yield value as shown on the TDS
 

Overview

Typical Applications

  • Grouting small gaps (<10mm) under baseplates
  • Crack repair material

Advantages

  • High compressive, tensile and flexural strengths
  • Resistant to repetitive dynamic loads
  • Fast, convenient installation with early strength gain
  • Withstands a wide range of chemicals
  • Non-shrink and hence ensures complete surface contact and bond
  • Low creep characteristics under sustained loading

Key Properties

  • 28 day strength @ 20°C dependent on consistency (cube samples) : 83 MPa
  • Application method : Gravity feed, pressure injection
  • Chemical resistance : Resistant to oil, grease, fats, most chemicals, mild acids and alkalis, fresh water and sea water
  • Flexural Strength (modulus of rupture) @ 28 days : 30 MPa
  • Gap size : 01 mm to 10 mm
  • Indirect tensile strength @ 28 days : 15 MPa
  • Pot life @ 20°C : 20 mins
  • Service temperature : 10°C to 45°C
  • Tack free time : Free flowing

Test Certificates

Application Guides

Spec Clause

Brochures

Product Calculator

Enter dimensions of your application to caclculate the volume and the bag/kit quantity you will need.

Note: This calculator should be used as a guide only to determine product quantity requirements. Coverage rates can vary, depending on a number of factors, so for specific advice, please refer to the TDS, and/or call your Account Manager or our Customer Service team to discuss your application requirements.

enter the yield value as shown on the TDS
 

Technical Data Sheet

Conbextra EP10 TDS